Products
Anodes
Bow & Stern Thrusters
Cruisair Air Conditioning
Instrument Housing
Lighting
Down Lights
Spot Lights
Reading Lights
Wall Lights
Courtesy Lights
Chart Lights
Fluro Lights
Frensch 'Resolux 505'
Frensch 'Resolux 600'
Frensch 'Resolux 650'
Frensch 'Resolux 720/730/750'
Frensch 'Resolux 760/770'
Underwater Lights
Exterior - Navigation
Exterior - Floodlights
General
NEW LIGHTING
Marine Plumbing
Marine Pumps
Mobile TV
Rudder & Steering Systems
Sanitation & Bilge
Shaft Seals
Trim Tabs
Water Lubricated Bearings
Watermakers
Winches & Windlasses
NEW PRODUCTS
Products
\
Lighting
\
Fluro Lights
Print this article
Frensch 'Resolux 650'
Sturdy plastic ABS housing
Macrolon diffuser with prism structure
Fluorescent TL 6, 8 or 2 x 8 W, warm or coolwhite
With switch
IP 40
Recessed screw mounting
Features
Images
Flicker-free pre-heat-soft start, securing long lamp life; starting time less than 2 sec.
Recognition of technical faults, automatic shut-down of lamp
Plated through HI-TEC electronics in SMD technology with low-loss polarity reversal protection and over-current protection in case of overheating
Noise-suppressed under EN55015, compliant with EMC regulations 95/28/EC, 95/54/EC, 89/336/EEC
Will always operate at its optimum thanks to its integrated automatic control system
Very constant luminous energy over the entire operation voltage
No stroboscope effect or flickering due to fluctuations in on-board mains voltage
Automatic restart after replacement of lamp
With or without switch available
Connection via 6.3 mm AMP flag or two core silicone cable
Light source
T5 standard miniature fluorescent lamp 4, 6, 8 and 13 W
T5 High effi cient lamp 14, 21, 28 and 35 W
TC-EL Compact lamp 7 or 11 W
PL-L Compact lamp 18, 24 and 36 W
Available in various light colors: coolwhite (4,000 K), warmwhite (2,900 K) and extra warm (2,700 K = like an incandescent bulb)
Mean working life of the fluorescent lamps is 10,000 hours
Housing
RESOLUX® 500, 600 and Compact Line are made of ABS and PC
RESOLUX® 700 / 900 and Highlite. Body made from die-cast aluminium, anodized or powder-coated. End-cap made from ABS
Diffusers with longitudinal prism structure made from PC, very impact-resistant
Click here to enlarge
AVAILABLE FILES
Full Frensch Catalogue & Specifications
© 2012 Lighthouse Marine | Site by
Tin Soldier